Pin 13
Pin 14
Pin 15
Pin 16
Automation and remote LED connector schematic
Figure 5 ADI-LED connector schematic
.
Notes:
•
The maximum LED current supported is 25 mA.
•
There should be a current limiting resistor on each LED output.
•
The maximum off voltage on the transistor collector must not exceed 5.5V.
•
The maximum on voltage for the transistor is 0.4V.
•
The same circuit configuration as shown in
•
The library-controlled or Beacon LED is driven by the AMI_LED_OUT signal.
Figure 6 LED driver circuit
.
Port 2 Status LED output
Host controlled (Beacon) LED output
Encryption LED output
5V supply
Figure 6
on page 39 is used for all LED ports.
Volume 1: hardware integration
39