HP LTO Ultrium Technical Reference Manual page 98

Code Description
Drive control has set drDriveStatus to DR_FW_UPGRADE.
2D09h
2D0Ah Immediate LOAD/UNLOAD in progress.
2D0Bh Reported when an Immediate command is executing and a subsequent command is received.
2D0Ch I_T nexus loss occurred.
2D0Dh The maximum number of surrogate logical units have been defined.
2D0Eh The supplied surrogate inquiry page is incorrect.
2D0Fh The surrogate logical unit inquiry area is full.
2D10h The surrogate logical unit inquiry area has been corrupted.
2D11h The operation has been denied as the SCSI port is currently enabled.
2D12h ACI has attempted a surrogate SCSI status operation without first setting up any sense data.
2D13h This is no nexus live for this surrogate logical unit.
2D14h An invalid SCSI status value has been supplied.
2D15h Can not process this command, for some reason send it to lib.
The hiConfigureSurrogateLunOp has resulted in a LUN being deleted.
2D16h
2D17h Unsupported Sub pagecode
2D18h First burst.
2D19h ACK NAK timeout.
2D1Ah NAK received.
2D1Bh Initiator response timeout.
2D1Ch Data offset error.
2D1Dh Information Unit too short.
2D1Eh Too much write data.
2D1Fh Chan1 detected a CRC error and a subsequent check of the buffer found the CRC good.
2D20h Chan1 detected a CRC error and a subsequent check of the buffer found the CRC bad.
2D21h Test function in progress.
2D22h Invalid configuration action.
2D23h Firmware defect; caller specified an invalid Relative Target Port.
98 Drive error codes