HP LTO Ultrium Technical Reference Manual page 141

Error Description
948Ah Decrypt key fail limit reached. Exhaustive search attack prevention.
948Bh Stored HAT count in NV is greater than Max HAT Retries.
948Ch Stored default Map ID for this port is invalid.
Write command allocation length error. If encryption mode is set to encrypt, only 8 MB record
948Dh
size is allowed.
948Eh Too many stalled auto mode commands already exist in the slow device server queue.
948Fh The drive has detected invalid sense data from the remote SMC device server.
9490h KMS did not provide a key.
9491h Parameter list length error in the CDB.
9492h A command descriptor in the Set Snapshot Command Set parameter list was truncated.
9493h The configuration descriptor in the Set Snapshot Config parameter list was truncated.
9494h Failed to start the Service Buffer snapshot because one is already in progress.
9495h SI RSA Signature Known Answer Test has failed.
Cannot set security parameters, the drive has been (externally) configured not to accept se-
9496h
curity parameters.
KMS reported it failed to obtain security parameters, without which the command cannot be
9497h
executed.
9498h KMS reported it failed to obtain security parameters, unrecoverable error.
9499h KMS reported it failed to obtain security parameters; error when trying to access the key.
949Ah KMS reported it failed to obtain security parameters, key not found.
949Bh KMS reported it failed to obtain security parameters, incorrect key.
949Dh Timer expired when waiting for security parameters from KMS.
949Eh Encryption UA.
KMS reported it failed to obtain security parameters, request not authorized (for example,
949Fh
the loaded tape is not encryption capable).
94A0h The drive is in a special maintenance or self-test mode.
94A1h The parameter list of a SET LIVE TRACE POINTS/VARIABLES command was truncated.
94A2h The parameter data of a SET TIMESTAMP command was truncated.
94A3h Timestamp changed UA.
94A4h Failed to initiate an SPI transfer to read an STTF log from flash memory.
94A5h The parameter data of a SET SERVICE LOCATION command was truncated.
94A6h Cannot enable an NPIV port when the physical port is in Loop mode.
Volume 1: hardware integration 141