Exception Handler (From 7800H) - HP LTO Ultrium Technical Reference Manual

Error
7710h
7711h
7712h
7713h 771Fh
7720h
7721h 772Fh
7730h
7731h 773Fh
7740h
7741h
7742h
7743h
7744h 7745h
7746h
7747h
7748h 774Ah
774Bh
774Ch
774Dh
774Eh 774Fh
77nn h
(nn=50h FEh)
77FFh

Exception handler (from 7800h)

Error
7800h
7801h
7802h
132 Drive error codes
Description
DSP fault: unable to find a top servo band.
DSP fault: unable to lock to track 0 on a top servo band.
DSP fault: unable to verify band ID on a top servo band.
DSP faults: spare.
DSP fault: the track-following loop could not stay at the desired set point.
DSP faults: spare.
DSP fault: could not stay locked to the tape servo code.
DSP faults: spare.
DSP fault: no tape servo data during seek acceleration phase.
DSP fault: acceleration time-out fault.
DSP fault: spare.
DSP fault: no tape servo data during the seek deceleration phase.
DSP faults: spare.
DSP fault: seek failure during VI gross settle.
DSP fault: seek failure during tape gross settle.
DSP faults: spare.
DSP fault: no tape servo data during seek fine settle phase.
DSP fault: too few samples to generate an azimuth correction.
DSP fault: too few samples to generate a valid timing reference.
DSP faults: spare.
DSP fault Code nn.
Denotes the end of DSP error codes. This is not an actual error.
Description
Unrecognized exception.
A Fatal assert has been seen. Parameter 1 shows the PC, parameter 2 the error code for the
assert.
A Logged assert has been called. Parameter 1 shows the PC, parameter 2 shows the File ID,
parameter 3 the line number.