Operating System (From 4400H); Physical Formatter (From 4C00H) - HP LTO Ultrium Technical Reference Manual

Error
40D4h
40D5h
40D6h
40D7h
40D8h
40D9h

Operating system (from 4400h)

Error
4400h

Physical formatter (from 4C00h)

Error
4C00h
4C01h
4C02h
4C03h
4C04h
4C05h
4C06h
4C07h
4C08h
4C09h
4C0Ah
4C0Bh
110 Drive error codes
Description
The PCA2 EEPROM is not supported on this platform.
An unknown KMS security parameter was asked for.
The KMS security parameter was encrypted, however the encrypted record size ends up
being too large for storage
The Initialization check of the KMS security table showed a bad CRC on the directory entries.
The whole table must be cleared and rebuilt.
The KMS Security table does not have an entry for the KMS security parameter requested
(tha is, it is not stored in the table).
The Secure EEPROM storage will only allow encryption of field sizes divisible by 16, such
as 16, 32, 48 and so on.
Description
'vGiveSem' failed to signal a semaphore.
Description
C1 has finished before C2 is ready for the dataset.
The physical formatter has been sent an invalid configuration name.
The physical formatter has been sent an invalid configuration value
C2 hardware is busy. The physical formatter C2 hardware is currently processing a dataset.
The physical formatter C2 control DS0 register go bit is set.
The physical formatter C2 control DS1 register go bit is set.
The physical formatter C1 control register go bit is set.
The physical formatter CCQ Reader control register go bit is set.
The physical formatter Read Chain Controller control register go bit is set
The physical formatter has been asked for the error rate log for a channel which does not
exist
The physical formatter has been asked for the error rate logs for a channel which does not
exist.
The physical formatter could not set the callback timer to enable the Hyperion read gate.