HP LTO Ultrium Technical Reference Manual page 140

Error Description
9470h Invalid Product ID.
9471h Medium removal prevented.
9472h Forward task to drive. Not a reportable error code.
Logout in bad state. The Bridging Manager received notification of an ADT port Logout while
9473h
waiting for TMF response to abort synchronizing PAMR command.
Not reserved. If the OIR bit is set in Device Config mode page, commands will return this if
9474h
there is no persistent reservation.
9475h Initialization in progress. The Automation Controller is initializing the drive.
Invalid field in medium attribute. An invalid field is the SCSI Set Medium Attribute command
9476h
parameter list.
Truncated medium attribute. A medium attribute in a SCSI Set Medium Attribute parameter
9477h
list is truncated.
Invalid field in Log Data cache. An invalid field in the SCSI Set Log Data Cache command
9478h
parameter list.
Truncated log page descriptor. A log page descriptor in a SCSI Set Log Date Cache command
9479h
is truncated.
947Ah Invalid field in parameter list.
947Bh Invalid field in SP Out data.
947Ch SP Out parameter list length error in CDB.
947Dh Data encryption parameters changed by another initiator Unit Attention.
947Eh Data encryption parameters changed by vendor specific event Unit Attention.
947Fh SP Key instance CTR changed.
9480h Unsupported encryption cartridge.
Firmware upgrade already in progress. Another initiator has already started a FW download
9481h
sequence.
9482h Firmware upgrade image not MOD4.
9483h Firmware upgrade image has bad CS on first chunk.
9484h Firmware upgrade reboot in progress.
9485h The boot info area of the serial flash is corrupt. EnFUG command set will not work.
9486h No key is available when asked to encrypt or decrypt.
9487h SetManagementURI command is only allowed when the drive is not ready.
Parameter list length specified has too many URI descriptors. Only used with the SetManage-
9488h
mentURI command.
9489h Logical EOT has been detected.
140 Drive error codes