HP LTO Ultrium Technical Reference Manual page 147

Error Description
A008h The acceleration phase of the seek did not complete within the allotted time.
A009h The deceleration phase of the seek did not complete within the allotted time.
A00Ah Settle window criterion was not met at the end of the deceleration phase of the seek.
A00Bh Hand-off to the tracking phase of the seek did not complete within the allotted time.
A00Ch Servo mode was not recognized during a seek.
A00Dh A timer fault occurred during a negative stiction pulse.
A00Eh A timer fault occurred during a positive stiction pulse.
A00Fh A timer fault occurred during the bottom crash stop calibration.
A010h A timer fault occurred during the top crash stop calibration.
A011h The measured actuator stroke size is too small.
A012h A timer fault occurred during TSB calibration.
A013h TSB0 calibration did not complete within the allotted time.
A014h TSB1 calibration did not complete within the allotted time.
A015h TSB2 calibration did not complete within the allotted time.
A016h TSB3 calibration did not complete within the allotted time.
A017h An invalid servo track number was specified for a seek.
A018h The calculated final target for a VI seek was out of range.
A019h The calculated final target for a Tape seek was out of range.
A01Ah Unable to find the requested TSB.
A01Bh Unable to find Servo code on the tape; bad head.
A01Ch Unable to identify the current Top Servo band.
A01Dh Unable to identify the requested Seek type.
A01Eh Unable to lock to tape when not tracking on VI.
A01Fh Unable to lock to tape servo code within the allotted time.
A020h Primary servo bump went out while writing.
A021h System ARM is not allowing tape servo operations.
A022h VI offset calibration has not been done.
A023h The specified servo scope mode is not valid.
A024h The specified servo scope channel bit width is not supported.
A025h The specified servo source number is not valid.
Volume 1: hardware integration 147