HP LTO Ultrium Technical Reference Manual page 94

Code Description
2C88h The Log Sense PC Code is in error.
2C89h Log Select: error in the parameter header.
2C8Ah Restart the Logical Pipeline after a format error.
2C8Eh The Buffer Manager has been interrupted with an error.
2C8Fh Check the cables. The Host Interface has exhausted all of the retries for a data phase.
2C90h Log Select parameter list length error.
hiPopulateSenseBuffer() could not find any free sense data buffers.
2C91h
The failure prediction threshold has been exceeded. This error code is sent when a check
2C92h condition is generated for a CDB as a result of the Test flag being set in the Information Ex-
ceptions Mode page.
Reset after GE. Triggers the power-on self-test UA 2900 after LTO 1 SCSI ASIC GE has been
2C93h
detected.
2C94h Return GOOD status. Used to force GOOD status to be returned.
2C95h There is a firmware bug in the handling of an inquiry page.
There is a firmware bug in the execution of the Prevent/Allow Medium Removal com-
2C96h
mand.
2C97h There is a firmware bug in the parsing of a Mode page.
2C98h An attempt was made to write data or filemarks inside EW-EOM.
2C99h Firmware incorrectly programmed the SCSI macro.
2C9Ah An unsupported LUN was specified in the SCSI Identify message.
2C9Bh Aborting a previous command.
Aborting and no disconnect. A command was rejected that could not be queued while an
2C9Ch
abort was in progress.
2C9Dh The host interface has exhausted all of the retries for a command phase.
2C9Eh Parameter not supported. A request for an invalid page code has been sent.
Buffer offset good. This is used internally by the Read Write Buffer code and should never
2C9Fh
be reported to the host.
Operation in progress. Reported when an Immediate command is executing and a subsequent
2CA0h
command is received.
Illegal length record (ILI) — too long, and there is an EOR in FIFO. This occurs when a record
2CA1h
is long by less than the FIFO length.
2CA2h Illegal length record (ILI) — too short with bad CRC.
2CA3h Illegal length record (ILI) — too long with bad CRC.
2CA4h LUN not configured. The drive is the process of becoming ready.
94 Drive error codes