Diagnostic Control (From 1800H) - HP LTO Ultrium Technical Reference Manual

Diagnostic control (from 1800h)

Code
1800h
1801h
1802h
1803h
1804h
1805h
1806h
1807h
1808h
1809h
180Ah
180Bh
180Ch
180Dh
180Eh
180Fh
1810h
1820h
1821h
1822h
1823h
1830h
1831h
1840h
1841h
1842h
1843h
1844h
84 Drive error codes
Description
No errors.
Invalid command.
Invalid parameters.
Drive not ready.
Command failed.
Command aborted.
Too few parameters.
Too many parameters.
Command denied.
Operation code not supported in diagnostic CDB command.
Page code not supported in diagnostic CDB command.
Buffer code not supported in read/write buffer command.
Parity error on serial receive.
Framing error on serial receive.
Overflow error on serial receive.
Excessive input length, exceeding 220 characters.
Power-on self-test not executed.
Error detected during the Register Walking 1 test.
Built-in self-test failure.
No test available for the parameters provided.
Error detected during the Memory test.
Power-on self-test failed the processor internal SRAM data bus test.
Power-on self-test failed the processor internal SRAM address bus test.
Power-on self-test failed the DRAM MPU Port test.
Power-on self-test failed the DRAM Data Bus test.
Power-on self-test failed the DRAM Addr Bus test.
Power-on self-test failed the Formatter ASIC Register test.
Power-on self-test failed the Formatter ASIC built-in self-test).