109
EVM Reports and Printing
Figure 6-9: Logging EVM setups EVM and auto-run setting
EVM and auto-run setting
The EVM has four programmable auto-run settings including a timed run, a date, a day of week (DOW), and a disabled mode.
The following Auto-Run settings are briefly explained below:
Timed-Run mode: With Timed Run, the EVM is powered on and run is enabled. The EVM will automatically stop based on the
programmed duration.
Date mode: With Date mode, With the date mode, it will wake up the instrument from a powered down or on condition, runs the study,
saves it, then powers down again. Up to four date settings are programmable with a specified date, time (in hours, minutes, seconds),
and duration via the softkeys.
Days of week mode: The days of the week (DOW) setting is a pre-programmed weekly auto-run with a specified day, start time, and
duration with two auto on settings. The programmable settings include a day of the week, start time, and duration.
Timed-Run and auto-run setting
To enable the Timed-Run mode, please follow below.
1. Click on the Auto-Run tab (see 1) from the EVM's Instrument Communications panel.
2. Click in the
Enabled checkbox and click in the
3. Ensure Timed-Run tab is selected (see 2) below and select the Duration by either using the
4. To set the auto-run, click on
configurations".
Figure 6-10: EVM Timed-Run Auto-Run setting
Date and auto-run setting
To enable Date mode, please follow below.
1. Click on the Auto-Run tab (see 1) from the EVM's Instrument Communications panel.
2. Click in the
Enabled checkbox and click in the
3. To enable (or activate) a Date setting, click on the Enabled
To set the start date, either use the icon or type in a date value.
To set the start time and duration, either use the
or save and send to the EVM (for more details see "Saving and sending
1
2
Timed-Run field.
3
Date field (See 2).
for Date 1 (See 3).
arrows or type in a numeric values.
arrows or type in a duration value.