Setting Up A Custom Test Type On A Test Point Within A Sample Plan; Performing A Retest On A Custom Test Type - 3M LM1 User Manual

Setting Up a Custom Test Type on a Test Point within a Sample Plan

If a Sample Plan does not appear, tap scroll up
Sample Plans.
• If you are restarting a Sample Plan that you did not complete, tap the Sample Plan with the starting date and time
you want. If that Sample Plan does not appear, tap scroll up
Plan names.
• The List View appears, showing a list of the Test Points in the Sample Plan, and the number of Test Points in each
result category:
• To select a Test Type, tap [Test types...] then tap the Test Type to be performed. Tap [Done].
1. To select a Test Point to be tested, tap the Test Point
• If a Test Point includes an ATP test and a Custom Test Type, the Custom Test Type appears immediately after the
ATP test.
• You can test points in the Sample Plan in sequence or in any order. The first Test Point in the Sample Plan appears on
the screen. If you want to test a different Test Point, tap Next Test Point
can display a previous test point by tapping Previous Test Point
• To display an image and a description of the Test Point, tap information
to return to the previous screen.
2. Tap the gray bar that appears below the test type. Tap [Enter value] . Use the number pad to enter the test result. To
remove a number you entered incorrectly, tap backspace
3. The test result appears on the screen and is stored in the memory so it can later be synchronized with the 3M
Clean-Trace Hygiene Management Software. The test result is also interpreted using the pass/fail limits and the test
result status is displayed on the screen as PASS
4. The next Test Point in the Sample Plan you selected appears on the screen. You can repeat the process starting with
step 5 to enter a test result for the Test Point that's displayed on the screen.

Performing a Retest on a Custom Test Type

1. To select the Test Point you want to retest, tap Next
then tap Next or Previous
a. To display a picture and a description of the Test Point, tap information
to return to the previous screen.
2. Tap the field. Use the number pad to enter the test result. To remove a number you entered incorrectly, tap backspace
, then enter the correct number. Tap [Done].
3. The test result appears on the screen and is stored in the memory so it can be synchronized with the 3M Clean-Trace
Hygiene Management Software. The result is also interpreted using your established pass/fail limits and is displayed on
the screen as PASS
or scroll down
Total number of
Test Points
to move to the Test Point you want to retest.
, CAUTION , or FAIL
.
or swipe the list up or down to display additional
or scroll down
Number in Number in
Pass Caution
category category
until the test point you want appears. You
.
, then enter the correct number. Tap [Done].
, CAUTION , or FAIL .
or Previous . To use a different Sample Plan, tap Home
12
EN
(English)
to display additional Sample
Number in
Fail
category
next to the Test Point name. Tap [Back]
next to the Test Point name. Tap back
,