Setting The Receiver Clock; Selecting A Language; Enabling/Disabling Frequencies - 3M Dynatel 2250ME Series Operator's Manual

B. Setting the Receiver Clock
Set the time, date, and date format of the receiver. Depth and Current measurements are
time and date stamped, as well as read write marker information (iD units only).
1. Press the left/right arrow [SK] to highlight the
digit of the date or time to change.
2. Press the + or - [SK] to increment or decrement.
3. When the date format is highlighted, the format
will toggle between mm/dd/yy and dd/mm/yy.
4. Press Locate/OK [5] to save, or Menu [6] to
cancel.
C. Selecting a Language
The soft key command will cycle through available languages. Press Locate/OK [5].
Alternate languages can be uploaded to the receiver using the 3M™ Dynatel™ PCTools
software. The 3M Dynatel PC Tools software is available free of charge at www.3M.
com/dynatel under the Software section; 2550/2573/2250M/2273M/1420 Locator PC
Tools xx.x.x (EXE xx.xMB).
D. Enabling/Disabling Frequencies
The user can select the frequencies that the receiver will detect. All the available
frequencies are listed in four groups (Left to Right: Active, Power, Passive, and
Auxiliary). The Auxiliary group also contains the User Defined Frequencies. (See
Creating User Defined Frequencies, Section 5F).
1. Press the right arrow [SK] to move the highlight
bar to the section of frequencies to enable, or
disable.
2. Press the up/down arrows [SK] to highlight the
specific frequency.
Press Enabl/Disabl [SK]. (Enable denoted by )
3.
4. Repeat steps 2 & 3 to enable/disable other
frequencies.
Press Locate/OK [5] to save.
5.
78-8130-6151-8 Rev G 17