Figure 3-7: Pid Correction Factor; Figure 3-8: Pid Correction Factor Displayed On Measurement Screens - 3M EVM Series User Manual

28
Setting up parameters via the keypad
PID correction – adding/editing
2. Select PID by pressing
3. Press Enter
4. Press On/Off/Esc repeatedly to return to the start screen.

PID and correction factor
The applied correction factor "3.5" is
displayed in the Gas measurement screen.
on measurement screens
PID correction factor screen will appear.
to move to the value field. Press
change the value. Press Enter

Figure 3-7: PID correction factor

NOTE: When changing PID factor to a value excluding "1", the
PID correction factor will appear as a subscript on the
measurement screens. Two samples are displayed below:
Arrows and press Enter
to save your changes.
PID Factor number
Press up/down arrows on
keypad to change value.
Press Enter to save.
Default softkey
Press to restore PID factor
to default ("1").
PID and correction factor
Displayed in the Composite measurement
screen.
Figure 3-8: PID correction factor displayed
. The
Arrows to