13
Setup/instrument configuration
Auto-Run and setting timed run
Auto-Run and setting timed run
With a Timed Run mode, you program the instrument's duration (or timed run) and then manually start your
study. The Auto-Run will end when the duration expires.
Setting the Timed Run
1. From the setup screen, select Auto-Run by pressing the
2. Auto-Run will appear. To select disabled or timed run field, press the
Figure 3-7: Auto-Run screen
3. To select timed run, press
appear. (See Figure 3-8 below.)
Note: to turn off this feature repeat this step until disabled appears.
•
4. To enter in a time, press
and press
5. Press
Note: Remember to manually press Run key to begin the Timed Run.
•
/
key to move the time field. Using the
key while repeating this to move to the hours, minutes and seconds field.
key to save and press
Figure 3-8: Auto-Run screen
/
To activate, change the disabled field to
Timed Run following steps above.
keys until it appears and press
key twice to return to the measurement screen.
Timed run is set for 8 hours and 30 minutes
Sound Examiner SE-400 Series
keys and press
key.
key.
key. The duration field will
/
keys, change the time