Table of Contents
Advertisement
16
Turning off
Unit information screen
Turning off
When turning off the EVM, ensure you are in stop mode. A stop
indicator will appear on the top left next to the battery charge status
icon. If it is in run mode, stop the session and then proceed below.
1. From any measurement view or the start screen, press the On/Off
2. "3, 2, and 1" countdown will appear as the EVM is powered off.
Instrument Information
The general information screen also called the "unit info" screen is
used occasionally to check the type of instrument you purchased and
displays the serial number and firmware versions.
Unit information screen
Opening the unit info screen
1. Turn on the EVM by pressing the On/Off/Esc
2. In the start screen, press the down arrow repeatedly until Unit
EVM
Hardware
Revision
Look-up
key
Esc
.
Continue to press and hold until the instrument is powered off.
NOTE: to cancel the shutdown process, release the On/Off/Esc key
and it will return you to the screen you were previously viewing (i.e., PM
measurement screen).
Auto-Run Note: if an auto-run session has been set, the auto-run
summary screen is displayed prior to turning off. See section, Auto-Run
in Chapter 3.
Info is selected and press Enter
The unit info screen will appear.
Figure 2-4: Unit Information screen
.
.
Serial number
Firmware version of
other software
sub-system
Advertisement
Table of Contents
