Table of Contents
Advertisement
97
File System menu
Deleting sessions individually
NOTE: the particulates, toxic gas, CO
5. When viewing summary data, press
6. To return to the main screen, press On/Off/Esc
File System menu
With the File system menu, you can delete or clear sessions one-by-
one or delete all sessions. You can also verify the used and free
memory of the instrument via the Properties menu. The instructions
below explain the Session Directory menu, Delete All Session menu,
and the File System Proprieties menu.
Deleting sessions individually
1.
following measurement parameters: Min, Max, Avg, Max STEL, TWA. For
RH, Temp, and Air Velocity, the measurement parameters include: Max,
Min, and Avg.
Figure 5-17: Summary screen of a past session
summary data for each sensor. (This is similar to viewing
measurements during run or stop mode.)
In the summary data screen, the session run time will appear
in the upper hand corner of the display.
NOTE: For particulates summary data, it will display the impactor
setting applied during the measurement (i.e., PM4).
return to the Start screen.
Deleting sessions individually
Open the File System screen from the Start menu and select
the Session Directory menu. Then, press Enter
gas, and PID sensors will detail the
2
Session run time
Summary data
Measurements viewable
for particulates
PM4
Indicates the summary data
you are viewing.
Arrows to view
twice to
to open.
Advertisement
Table of Contents
