37
Setting up parameters via the keypad
Analog-out
Analog-out
The analog-out channel provides a voltage reading that is proportional
to the sensors output. The analog-out channel can be configured to
track any installed sensor.
The example displayed in Figure 3-12 shows the results of measuring
with the thermometer from 0 to 60ºC reading from 0 to 5 volts.
60
ºC 40
20
0
Figure 3-15: Analog out results with temperature as output
1.
2.
3.
4.
5.
0
1
2
3
Setting Analog-Out
From the setup screen, select Aux I/O and press Enter
Press
Arrows to select Analog-Out and press Enter
To enable or disable, press Enter
selected and press
Enter
to move back to the 1
To select a sensor, ensure Sensor is selected and press Enter
Then, press
Arrows to page through the selection list. Once
the appropriate sensor is selected, press Enter
To return to the start screen, press On/Off/Esc
Figure 3-16: Analog-Out screen
4
5
6
7
Arrows to change the setting. Press
st
column.
8
9 Hours
when Analog-out is
.
twice.
Disable/Enable Analog-out field
Select a Sensor
.
.
.