Table of Contents
Advertisement
Check the 3M
SpotOn
Temperature Monitoring System website to ensure you have the most recent version of this document.
TM
TM
Overview and Operation
Back of Control Unit
To view information and connections on the back of the control unit, assure that controller is viewed
from a distance no further than 15" (38 cm) from the operator.
(used by 3M personnel only)
The digital port is used only by 3M Patient Warming personnel for testing purposes and to access
variables within the control unit.
The monitor cable port provides a resistance that corresponds to a YSI-400 thermistor at the displayed
temperature. It is electrically isolated from the SpotOn control unit.
Front of Control Unit
Setting up the SpotOn control unit
1.
The SpotOn control unit must be properly installed and mounted by qualified personnel.
NOTE: The SpotOn sensor and control unit are suitable for use in the patient environment.
2.
Connect the power supply to the back of the SpotOn control unit (see Figure 5: Back of Control
Unit).
Plug the power supply into an appropriate outlet. The standby screen will illuminate.
3.
Connect the SpotOn sensor cable to the front of the control unit. See Figure 6: Front of Control
Unit for proper orientation and connection.
4.
If desired, use the provided monitor cable to connect the SpotOn control unit to the patient
monitor
(see Figure 5: Back of Control Unit).
NOTE: Temperature input on patient monitor typically labelled T1 or T2.
English 202052A
Digital Port
Monitor Cable Port
Figure 6: Front of Control Unit
Figure 5: Back of Control Unit
www.spotontemperature.com reorder #202052A
Stand Knob
°C/°F Temperature
Display Button
Power Input Port
9
Advertisement
Table of Contents
