3D Systems iPro 8000 SLA Center User Manual page 9

8000/9000
User's Manual
There are two operating modes for the RDM:
Stand-by Mode
In this mode, the RDM is offline and operates independently from the iPro 8000/9000 SLA Center,
permitting offline resin and module temperature stabilization when it is connected with line power
to the power umbilical. The resin can warm effectively in this mode, enabling the user to build a
part while warming resin for future use.
Build Mode
In this mode, the RDM is online and connects to the iPro 8000/9000 SLA Center for power and
I/O for full interoperability. The iPro 8000/9000 SLA Center monitors and controls the resin
temperature while connected with the active RDM. When the RDM is online, it can pump and
recirculate resin.
Intelligent Resin Container
Each container in the iPro 8000/9000 SLA Center holds an
electronic storage device that has information about the resin
that is in the bottle and the RDM. This information enables the
iPro SLA Center to make sure that the user does not use the
wrong material, use material incorrectly, or use an empty or
expired container.
9
www.3dsystems.com
F e a t u r e s
40-D043 Revision C 5-May-17