3D Systems iPro 8000 SLA Center User Manual page 32

O p e r a t i o n s
8000/9000
User's Manual
Refill Container 1 and 2: These removable containers store new resin, which is added to the
RDM as needed, prior to the start of a build.
Blade Rest: The blade rest area is used to stow the removable recoater blade when changing
RDMs.
Leveling Container: The system requires precise control of the resin height. This container acts
as a storage reservoir.
Note: Under normal operations, this container is not to be removed.
Valve Assembly: These valves control the resin flow from the refill containers and recirculate
resin.
Leveling Pump: The leveling pump controls the resin height in the RDM by moving resin to or
from the leveling container.
RDM Heater Power Switch: This switch enables warm up of the RDM, whether in the system or
offline.
I/O Connector: This connector is the interface for all communication and motion control
between the RDM and the iPro 8000/9000 SLA Center.
Gross Fill/Circulation Pump: This pump transfers resin from the refill containers into the RDM,
and recirculates resin already in the RDM.
40-D043 Revision C 5-May-17
www.3dsystems.com
32