3D Systems iPro 8000 SLA Center User Manual page 89

R e c o a t e r S y s t e m
8000/9000
User's Manual
RDM Removal
The RDM is made of stainless steel and has casters for moving and maneuvering it while
installing or removing it from the frame. There are also handles on the RDM that help to
transport and maneuver it into and out of the iPro 8000/9000 SLA Center.
1. Open the RDM door.
2. Exit the 3DPrint software (this will ensure the valve position on
the RDM is properly closed for removal).
3. Turn off the switch and disconnect the power cord. (See "RDM
Heater Power Switch")
4. Disconnect the cables. There is a black power cord and a gray
cable bundle. Unplug the three pronged black power cord from the
IEC receptacle on the RDM and take the connector out of the keys.
(See "RDM Umbilical Cord Receptacle" and "I/O
Connector".)
5. Disconnect the locking pin, located on the outer side of the
machine. (See "Locking
Pin")
6. Make sure that the elevator is at its lowest position the RDM out of the machine.
before you move
7. Make sure that the connecting cables are out of the way of the RDM before you take the RDM
out of the machine.
8. Place the RDM lid into position.
9. Take the RDM out of the machine and close the RDM door.
Recirculation
During periods of non-operation, the RDM can recirculate resin to improve resin uniformity and
life. For more information, see "Recirculate".
40-D043 Revision C 5-May-17
www.3dsystems.com
89