3D Systems iPro 8000 SLA Center User Manual page 59

8000/9000
User's Manual
Leveler
The manual Leveler controls the resin level in the RDM through the use of the gross fill and leveling
pumps on the front of the RDM. It also allows for the resin to recirculate.
Coarse Level:
Note: If the course level has not been performed first, the leveling bottle
can overflow or continue pumping when empty.
Move: Manually controls the leveling pump (Turns unit = pump revolutions).
Fine Level: Adjusts the resin level to the build start height by using only the leveling bottle and pump.
Recirculate: When machine is idle, recirculate resin in the RDM; clicking Recirculate starts
resin recirculation and changes the button to Stop Recirculate.
Clicking Stop Recirculate stops the recirculation.
59
Monitors the leveling container status and refills the RDM if resin is low.
www.3dsystems.com
M a n u a l O p e r a t i o n s
To Move the
resin level by a
set distance,
specify the
Turns and
Velocity.
40-D043 Revision C 5-May-17