3D Systems iPro 8000 SLA Center User Manual page 88

8000/9000
User's Manual
To use the RDM650, the iPro™ machine must have the rotary switch shown below installed. Some
iPro™ machines upgraded from Viper Pro™ may not have the limit sensor switch. Please verify that
this switch is on your machine before using the RDM650.
When an RDM 650 is detected, a message is displayed with the following instructions:
CAUTION: RDM650 detected. Please set limit sensor switch to the "650m".
(located in the rear left hand corner just below the Build Chamber E-Stop Switch)
For all other RDMs, the switch must be set back to the "STD" position.
Note: If the switch needed, but not present...
88
OK
www.3dsystems.com
R e c o a t e r S y s t e m
40-D043 Revision C 5-May-17