3D Systems iPro 8000 SLA Center User Manual page 94

8000/9000
User's Manual
1. Open the RDM door.
2. Obtain the resin container that is compatible with the resin that is in the RDM.
3. Remove the vent cap and puncture the small hole on the container.
Note: All containers have a depression in the areas to be punctured. Unless the
vent has been previously punctured, and you are very certain of this, puncture the
vent.
4. Pull the release lever of the slot in which you wish to install the container.
5. Insert the container into the supply container slot.
6. Look at the status on the user interface.
7. If the status is okay, push the container until the RFID cap is fully seated.
8. If the bottle is new, puncture the vent; otherwise go directly to Step 9.
9. Close the RDM door firmly, until it latches securely.
10. Close the resin container door firmly until it latches securely.
94
Caution!
Make sure that you have selected the correct resin container. Selecting a
container that is incompatible with the resin type in the RDM can damage
the machine.
www.3dsystems.com
R e c o a t e r S y s t e m
40-D043 Revision C 5-May-17