3D Systems iPro 8000 SLA Center User Manual page 65

8000/9000
User's Manual
Sensors
Sensor 2:
1/2: Moves beam to 1/2 mil pin hole on Sensor 2 (1 mil = 0.001 in.)
1: Moves beam to 1 mil pin hole on Sensor 2
2: Moves beam to 2 mil pin hole on Sensor 2
4: Moves beam to 4 mil pin hole on Sensor 2
65
Sensor 1:
Sensor 1 settings are the same as
sensor 2.
Note: Sensor 1 is not used in a single
or dual RDM hardware configuration,
therefore, the default values may not
be defined. Sensor 2 is utilized for
all hardware configurations.
www.3dsystems.com
S c a n n e r
40-D043 Revision C 5-May-17