3D Systems iPro 8000 SLA Center User Manual page 58

8000/9000
User's Manual
Home: Moves the recoater motion axes to their home positions and redefines the home position
(relative zero position of the recoater).
Velocity: Specifies the recoater speed, in inches or millimeters per second, during manual motion;
it does not affect motion during the move.
End: Moves the recoater to its rear limit.
Note: These values apply only to manual movement.
Action: Describes the current recoater action.
Status: Displays if the recoater has been reset by sending it to its Home location.
58
Move: Manually moves recoater as the user specifies.
Distance:
current position; negative moves recoater toward the front of
the machine, positive moves recoater toward the rear of the
machine.
Remove Bubbles: Runs a pre-defined operation to remove bubbles on
the resin surface.
Calibrate Recoater:
system.
Vacuum: Check Box
recoater's vacuum.
www.3dsystems.com
M a n u a l O p e r a t i o n s
Specifies distance, in inches or millimeters, from
Runs a pre-defined operation to calibrate the recoater
that allows the user to turn on/off the ZephyrTM
40-D043 Revision C 5-May-17