3D Systems iPro 8000 SLA Center User Manual page 70

8000/9000
User's Manual
Settings
70
Settings enables you to view/change the machine settings.
Name: Displays the resin.
Air Temp: Selects air temperature in degrees C.
RDM Temp: Selects the resin temperature in degrees C.
Alarm Temp:
off to prevent overheating.
Laser Max: Allows the user to slow the system down by lowering the
maximum power level to be used by the system.
Geo File: Displays the current IPM calibration file.
Laser Off Timer:
set number of minutes and the completion of a build.
Note: For dual RDM or XL configurations, only the left
side (A side) valve will be used.
PHD Distance:
enable PHD.
Note: Default and recommended setting is 0.
PHD = Post Hatch Delay
Note: If no RDM is installed, values will be undefined.
www.3dsystems.com
M a c h i n e W i n d o w
Selects the temperature at which the RDM heater shuts
Allows the user to set the laser to power off after a
Allows the user to specify the smallest vector length to
40-D043 Revision C 5-May-17