PS200
PORTABLE GAS MONITOR
6.5.2 Bump Test – Fail
If any range fails the bump test, the CONFIRM ALARMS display will be red and a
symbol will
be displayed, as shown in
Figure 47: Confirm Alarms -
Fail.
Figure 47: Confirm Alarms - Fail
After selecting YES or NO, BUMP TEST FAIL is displayed and the user is instructed to switch the
monitor off, as shown in
Figure 48: Bump Test Fail - Switch Monitor
OFF.
Figure 48: Bump Test Fail - Switch Monitor OFF
If a monitor fails a bump test, then a full re-calibration is necessary.
30
64171
Revision 12.1