Recharging The Batteries; General; Recharge Monitor Using The Charging/Comms Clip - Teledyne GMI PS200 User Manual

7. Recharging the Batteries

7.1. General

WARNING: NEVER ATTEMPT TO RECHARGE THE BAT TERIES IN A
HAZARDOUS AREA.
Caution: Switch the monitor off when charging.
Caution: Use only approved chargers to recharge monitor.
The battery should be recharged when:
• 'LOW BATTERY' or 'BAT FAULT' appears on the display.
• The monitor will not switch ON.
7.2. Recharge Monitor Using the Charging/Comms
Clip
1. Connect the supplied charging/comms clip to the monitor. Ensure the locating tongue on the clip
engages with the monitor locating slot and is firmly seated (refer to
Clip Connection).
Figure 49: Charging/Comms Clip Connection
2. Connect the supplied MINI-USB to USB Cable to the Charging/Comms Clip (as shown in
50: Connect Cable to Charging/Comms
64171
Revision 12.1
Figure 49: Charging/Comms
Clip).
PS200
PORTABLE GAS MONITOR
Figure
31