Table of Contents
Advertisement
PS200
PORTABLE GAS MONITOR
When this option is displayed (see
calibrate the monitor is identified between two arrowheads.
NOTE: The calibration certificate also identifies the calibration gas type used.
To select a different gas:
1. Press the L button to step through the options.
2. Press and hold the R button to select the required option.
NOTE: Accuracy for the re-selected gas type is ± 20%
3.3.8. Sensor Confirmation Check
The
symbol appears next to each sensor type to confirm that the sensor has been zeroed
correctly, as shown in
Figure 17: Sensor Check
refer to
Section 5.3. Zero Fault
3.3.9. Normal Operating Display
When warm-up is completed successfully, the backlight switches off and the normal operating
screen is displayed, as illustrated in
14
Figure 16: Cal Gas
Figure 16: Cal Gas Selection
Displays. If a wrench symbol
and
Section 5.4. Sensor Faults
Figure 17: Sensor Check Displays
Figure 18: 4-Gas Normal Operating
Selection), the original gas used to
Display.
Revision 12.1
is displayed,
64171
Advertisement
Table of Contents
