Sample Line Connection And Use; Pump Operation - Teledyne GMI PS200 User Manual

NOTE: The operation of the confidence beep and/or LEDs is configurable.

3.8. Sample Line Connection and Use

The monitor has an internal pump for remote sensing. Connect the sample line tubing to the sample
line connector, as shown in

3.8.1. Pump Operation

Press and hold the R button to start or stop the pump.
When the pump is running, a pump symbol
in the display.
NOTE: It is only possible to switch the pump ON / OFF when monitor alarms are
inactive.
NOTE: Pump cannot be switched OFF if monitor is configured with setting 'PUMP
ALWAYS ON'.
64171
Revision 12.1
Figure 21: Sample Line Connection. The pump is OFF after start-up.
Figure 21: Sample Line Connection
(as highlighted in
Figure 22: Pump Symbol
PS200
PORTABLE GAS MONITOR
Figure 22: Pump Symbol) rotates
17