Modifying The Machine; Fire Prevention; Cleaning And Disposing Of The Machine; Safety Devices On The Machine - Orved n Series Operating And Service Manual

GENERAL SAFETY STANDARDS AND ACCIDENT PREVENTION

2.4.9 MODIFYING THE MACHINE

DANGER!
• Do not alter the machine in any way without approval from ORVED S.p.A.
• Immediately replace all deteriorated, worn or damaged parts (qualified personnel must replace these parts).
• Only original spare parts are to be used.

2.4.10 FIRE PREVENTION

DANGER!
• Keep the vents free from obstacles (at least 10 cm away from any surrounding obstacle).
• Do not place the machine close to flammable products
DANGER!
• Risk of burns: ventilate the environment if alcohol-based or flammable disinfectants are used. Keep open flames
away from the machine! Do not smoke!

2.4.11 CLEANING AND DISPOSING OF THE MACHINE

ATTENTION!
• Clean the machine regularly, following the instructions in this manual.
• Use and handle detergents according to the manufacturer's instructions.
• Demolish and dispose of the machine, its components and detergents used to clean the machine, in compliance with
applicable Standards.

2.5 SAFETY DEVICES ON THE MACHINE

2.5.1 NOTES ON SAFETY DEVICES

• Before every machine start-up, check that all the protection and safety devices are present, efficient and functional. The
machine must not be used if one or more safety device is missing or damaged.
• Only qualified and trained personnel must perform maintenance and/or repairs or replace safety devices.
• The safety devices must not be excluded or disabled.
The machine comes standard with the following safety devices:
• Safety device to prevent the vacuum pump from overheating.
• Main switch.
• Safety fuses to prevent overloads and short-circuits.
• Vacuum pump fan cover.
2.5.2 SAFETY DEVICE THAT PREVENTS THE VACUUM PUMP FROM OVERHEATING
The machine is equipped with a safety system that eliminates the risk of the pump motor overheating, which could be
triggered by galling or a defect, by means of special temperature sensors placed on the motor winding and a number of
devices inside the electronic power board.
The control panel displays the alarm status (Chap. 9.2.2)
14
Rev. 08 - 04/2017 - Cod. 1500160 - Instruction manual VGP25N / VGP60N