Changing The Pump Oil - Orved n Series Operating And Service Manual

10.2 CHANGING THE PUMP OIL

For changing the oil use 1.2 litres of original oil. This oil is specially meant for use in vacuum pumps in the food packaging
sector: it has high anti-emulsion power with water, a factor which influences the pump life and working efficiency to a
considerable extent.
1) Run the pump for about 10 minutes so that the oil becomes fluid, by pressing "PUMP".
2) Stop the pump by pressing "PUMP".
3) Switch off the machine using the ON/OFF main switch and remove the plug from the power socket.
4) Remove the protection panel.
5) Unscrew filling screw
6) Use a container to hold the oil drained out and unscrew oil drain screw
the oil flow out into the container for about 10 minutes.
7) Refit the oil drain screw
C
on the pump .
Rev. 08 - 04/2017 - Cod. 1500160 - Instruction manual VGP25N / VGP60N
A
using a hex wrench.
B
and fill with the type of oil ORV60 to a level slightly above half-way on the level indicator
B
provided at the bottom of the pump. Let
A
C
ROUTINE MAINTENANCE
B
43