Changing The Pump Exhaust Filter; Cleaning The Chamber Filter - Orved n Series Operating And Service Manual

ROUTINE MAINTENANCE

10.3 CHANGING THE PUMP EXHAUST FILTER

WARNING!
This operation must be carried out by qualified personnel.
1) Switch the machine off by means of the ON/OFF main switch and remove the plug from the power socket.
2) Unscrew the cover of the pump exhaust filter
the rear of the machine, by turning it anticlockwise.
3) Remove filter B
from its seat.
4) Insert the new filter checking to make sure the O-ring
correct position.
5) Refit the cover A
by fixing spring
on the filter projection

10.4 CLEANING THE CHAMBER FILTER

The tank filter can be accessed from the rear of the chamber.
1) Switch the machine off by means of the ON/OFF switch and remove the socket from the mains power plug.
F
2) Unscrew filter cup
3) Wash the cup thoroughly with water, rinse and dry.
4) Clean the filter cartridge using compressed air.
5) Screw the cup clockwise, keeping screw
44
D
E
.
anticlockwise, keeping the screw
G blocked.
A
, accessible from
C
C
is in the
G
blocked using a No.10. hex wrench.
Rev. 08 - 04/2017 - Cod. 1500160 - Instruction manual VGP25N / VGP60N
A
F
B
D
E
G