HP StorageWorks Edge Switch 2/12 Installation Manual page 44

Installing and Configuring the Edge Switch 2/12
11. Choose File > Exit to close the HyperTerminal application. A message box
Figure 10: Disconnect Now dialog box
12. Click Yes. A message box displays
Figure 11: Save Session dialog box
13. Click No to exit and close the HyperTerminal application.
14. Power off the maintenance terminal:
15. Disconnect the RS-232 null modem cable from the switch and the
44
The IP address is always xxx.xxx.xxx.xxx, the subnet mask is always
yyy.yyy.yyy.yyy, and the gateway address is always
zzz.zzz.zzz.zzz. The octets xxx, yyy, and zzz are decimals from
zero through 255. If the IP address will not change from the one that was set
when you opened the session, then there is no need to reenter it here.
When the new network addresses are configured at the switch, the message
Request completed OK displays at the bottom of the
Edge Switch 2/12 — HyperTerminal window.
displays (Figure 10).
a. Choose Start > Shut Down. The Shut Down Windows dialog box
displays.
b. At the Shut Down Windows dialog box, choose Shut down the
Computer and click Yes to power off the PC.
maintenance terminal. Replace the protective cover on the maintenance port.
(Figure 11).
Edge Switch 2/12 Installation Guide