HP StorageWorks Edge Switch 2/12 Installation Manual page 60

Installing and Configuring the Edge Switch 2/12
2. Click Activate to save the information. The message "Your changes to
60
a. Click the Enable Authentication Traps check box to enable or disable
transmission of SNMP trap messages to configured recipients.
b. For each trap recipient to be configured, type a community name of 32
alphanumeric characters or less in the associated Community Name
field. The community name is incorporated in SNMP trap messages to
ensure against unauthorized viewing or use.
c. Click the check box in the Write Authorization column to enable or
disable write authorization for the trap recipient (default is disabled).
A check mark in the box indicates write authorization is enabled. When
the feature is enabled, a management workstation user can change
sysContact, sysName, and sysLocation SNMP variables
which correspond respectively to the Contact, Name, and Location
information configured under Configure Switch Identification.
d. Type the IP address or DNS host name of the trap recipient (SNMP
management workstation) in the associated Trap Recipient field. Use 64
alphanumeric characters or less. It is recommended the IP address be
used.
e. The default user datagram protocol (UDP) port number for trap recipients
is 162. Type a decimal port number in the associated UDP Port Number
field to override the default.
the SNMP configuration have been successfully
activated" displays.
Edge Switch 2/12 Installation Guide