Datcon DT4220 E Series Operating Instructions Manual page 12

Mounting with the
mounting clamps
12
1. Put on the enclosed seal onto the instrument case from the rear
side and fit it to the instrument holding frame (Figure step 1).
2. Put the instrument into the prepared cut-out until it possible and
check the fitting of the seal between case and mounting surface.
3. Put one of the enclosed mounting clamp onto the tip of a
screwdriver (A) and put the clamp with the help of the screwdriver into
the hole on the side of the instrument.
4. Push the mounting clamp with your finger tip as far as you can
while keeping the case in it's position.
Repeat the 4., 5. steps with the other clamp.
Please do not exercise forces higher than necessary, as it may cause
damages to the clamp.
DT4220 E
20180619-V0