Table of Contents
Advertisement
Wiring plan
Using of the push-in
direct connectors
20
5.6. Connecting the limit relay outputs (option)
The following figure shows the wiring plan:
The following figure shows the using of the push-in direct connectors.
The button can be pushed down easily. Please do not exercise forces
higher than necessary, as it may cause damages to the terminal
assembly.
1. Push the stripped cable-end until it possible into the terminal
assembly. In the case of flexible cable-ends, you can facilitate
opening the connection part by pushing down the white button.
2. By pushing the wire in, the self-closing connection is being
established. Check it by pulling it outwards firmly.
(3. When you are going to disassemble the cable, push down the
white button by a screwdriver, and pull the cable-end out.)
DT4220 E
20180619-V0
Advertisement
Table of Contents
