Setting-Up; First Steps - Datcon DT1102 V Operating Instructions Manual

DT1102 V
Necessary tools
Software

Setting-up

20230127-V0
7. Setting-up

7.1. First steps

For setting-up you need:
•
mini USB (5 pin) - USB A cable (accessory)
•
DT1102V_D.exe configuration software (accessory)
•
PC with Windows operation system and one free USB connector
Step 1:
install the USB driver for making the virtual serial port:
- Disconnect the USB cable from instrument.
- Connect the instrument with the USB cable to the PC USB port.
- If the windows runs the device installer application then browse and
select the file "DT1102 V\USB Driver\MCP2200_v1.2.inf" and install it.
Another method (if the first method failed): run the
application"DT1102 V\USB Driver\Driver Installation
Tool\xxx\MCP2200DriverInstallationTool.exe".
Step 2:
Easy to use DT1102V_D.exe configuration software (free of charge).
Simple copy it into an optional folder, click on the "Start" button and
you can configure the instrument.
1. Connect the instrument with the USB cable to the PC USB port and
put it under supply voltage.
2. Start the DT1102V_D.exe configuration program.
3. Select the appropriate serial port. (Baud rate must be 115200.)
4. Click on the „Open" button.
5. Use the configuration software as is written on the following pages.
6. At the end of the settings click on the
"Write settings to instrument" button, the new settings are written into
the instrument.
7. Click on the „Close" button for finishing the configuration procedure
and disconnect the USB cable.
8 Close DT1102V_D.exe configuration program.
21