Connecting The Transmitter Supply (Ts) Output (Option); Final Steps - Datcon DT4220 E Series Operating Instructions Manual

Wiring plan
Checking the
connections
Put the instrument
under supply voltage
,
24

5.10. Connecting the transmitter supply (TS) output (option)

The following figure shows the wiring plan:
1. Pull out the terminal so you can make connection easier.
2. Loosen terminal screws.
3. Insert the wire ends into the open terminals according to the wiring
plan.
4. Screw the terminal in.
5. Check the hold of the wires in terminals by pulling on
them firmly.
6. Push in the terminal.

5.11. Final steps

Check if the cables are connected properly (have you connected all
the cables, have you connected to the right place, do not the cable-
ends touch each other).
After you have completed the connections, put the instrument under
supply voltage. If the supply connection is correct the display gives
light.
DT4220 E
20180619-V0