Table of Contents
Advertisement
DT4220 E
Dismounting
20180619-V0
9. Dismounting
9.1. Dismounting procedure
The following figure shows the dismounting procedures:
Before put off power supply and disconnect all wires.
1. Slip the tip of the screwdriver into the hole of the mounting clamp
(A) (Figure step 1).
2. Move the screwdriver handle to make free the clamp (Figure step
2).
3. Keeping the screwdriver in this position draw back the mounting
clamp (Figure step 3).
Please do not exercise forces higher than necessary, as it may cause
damages to the clamp.
4. Repeat the 1., 2., 3. steps with the other clamp.
5. You can take out the instrument from the panel cutout (Figure step
4).
9.2. Disposal
According with the concerning EU directive, the Manufacturer
undertakes the disposal of the instrument that are manufactured by it
and intended to be destroyed. Please deliver it in contamination-free
condition to the site of the Manufacturer or to a specialised recycling
company.
51
Advertisement
Table of Contents
