Pcie Mezzanine Cards - Dell PowerEdge M630p Owner's Manual

Steps
1. Align the standoffs on the processor or DIMM blank with the heat sink retention sockets on the processor socket.
2. Lower the processor or DIMM blank onto the system until the standoffs on the processor or DIMM blank engages with the heat sink
retention sockets.
Figure 20. Installing a processor/DIMM blank
a. processor or DIMM blank
b. heat sink retention socket (4)
c. standoff (4)
Next steps
Follow the procedure listed in the After working inside your system section.
Related References
Safety instructions on page 51
Related tasks
Installing a processor on page 90
Removing a processor or DIMM blank
Before working inside your system
After working inside your system

PCIe mezzanine cards

The server module supports two x8 PCIe Gen 2 mezzanine cards. No other mezzanine cards, such as Ethernet, Fibre Channel, or
InfiniBand are supported on server modules configured for the PowerEdge VRTX enclosure.
The PCIe mezzanine cards provide an interface between server modules and the PCIe switches in the enclosure.
NOTE: You cannot operate the system with a single PCIe mezzanine card. Two PCIe mezzanine cards are required per
server module to support the PCIe expansion cards and PERC card-based shared storage on the enclosure.
NOTE: For proper operation, make sure that both PCIe mezzanine cards are set to Enabled in the System Setup.
70 Installing and removing server module components
on page 68
on page 51
on page 52