Dell PowerEdge M630p Owner's Manual page 34

• If System Password is not set to Enabled and is not locked through the Password Status option, you can assign a system
password. For more information, see the System Security Settings screen section.
• You cannot disable or change an existing system password.
NOTE: You can use the password status option with the setup password option to protect the system password from
unauthorized changes.
Related References
System Security on page 30
System Information
You can use the System Information screen to view system properties such as Service Tag, system model name, and the BIOS version.
Related References
System Information details
System BIOS on page 25
Related tasks
Viewing System Information
Viewing System Information
To view the System Information screen, perform the following steps:
Steps
1. Turn on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click System Information.
Related References
System Information on page 34
System Information details
About this task
The System Information screen details are explained as follows:
Option Description
System Model Specifies the system model name.
Name
System BIOS Specifies the BIOS version installed on the system.
Version
System Specifies the current version of the Management Engine firmware.
Management
Engine Version
System Service Specifies the system Service Tag.
Tag
34 Pre-operating system management applications
on page 34
on page 34