Installing The Hard Drive Or Ssd Backplane - Dell PowerEdge M630p Owner's Manual

Figure 57. Removing the 1.8-inch (x4) SSD backplane
1. hard drive or SSD backplane
3. release latch (2)
5. retention screw on the backplane cable connector (2)
Next steps
1. Install the hard drive or SSD backplane.
2. Install the hard drive or SSD.
3. Follow the procedure listed in the After working inside your system section.
Related References
Safety instructions on page 51
Related tasks
Before working inside your system

Installing the hard drive or SSD backplane

Removing a hard drive or SSD
Removing the hard drive or SSD cage
After working inside your system
Installing the hard drive or SSD backplane
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that came with the product.
NOTE: You must remove the hard drive or SSD backplane to replace a faulty hard drive or SSD backplane or service
other components inside the system.
on page 51
on page 107
on page 94
on page 103
on page 52
2. hard drive or SSD backplane cable
4. guide pin (3)
6. connector on system board
Installing and removing server module components 107