Internal Usb Key - Dell PowerEdge M630p Owner's Manual

Internal USB key

The server module provides an internal USB connector for a USB flash memory key. The USB memory key can be used as a boot device,
security key, or mass storage device. To use the internal USB connector, the Internal USB Port option must be enabled in the
Integrated Devices screen of the System Setup.
To boot from the USB memory key, you must configure the USB memory key with a boot image, and then specify the USB memory key in
the boot sequence in the System Setup. For information on creating a bootable file on the USB memory key, see the user documentation
that shipped with the USB memory key.
Replacing the internal USB key
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that came with the product.
CAUTION: To avoid interference with other components in the server module, the maximum permissible dimensions of
the USB key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1. Follow the safety guidelines listed in safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
Steps
1. Locate the USB connector/USB key.
2. If installed, remove the USB key.
3. Insert the new USB memory key into the USB connector.
Figure 25. Replacing the USB memory key
a. USB memory key
b. USB memory key connector
Installing and removing server module components 75