Removing A Processor - Dell PowerEdge M630p Owner's Manual

Allow some time (around 30 seconds) for the heat sink to loosen from the processor.
2. Loosen the screw that is diagonally opposite the screw you first removed.
3. Repeat the procedure for the remaining two screws.
4. Remove the heat sink.
NOTE: Set the heat sink upside down on the work surface to avoid contaminating the thermal grease.
Figure 35. Removing a heat sink
1. retention screw (4)
3. processor socket
Next steps
1. Replace the heat sink(s) and processor(s).
2. Follow the procedure listed in the After working inside your system section.
Related References
Safety instructions on page 51
Related tasks
Before working inside your system
After working inside your system
Removing the cooling shroud
Installing a heat sink on page 91
Installing a processor on page 90

Removing a processor

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that came with the product.
CAUTION: Never remove the heat sink from a processor unless you intend to remove the processor. The heat sink is
necessary to maintain proper thermal conditions.
on page 51
on page 52
on page 66
2. heat sink
4. heat sink retention socket (4)
Installing and removing server module components 87