Removing Memory Modules - Dell PowerEdge M630p Owner's Manual

Removing memory modules

Prerequisites
WARNING: The memory modules are hot to touch for some time after the system has been powered down. Allow time
for the memory modules to cool before handling them. Handle the memory modules by the card edges and avoid
touching the components or metallic contacts on the memory module.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that are shipped with your product.
CAUTION: To ensure proper system cooling, memory module blanks must be installed in any memory socket that is not
occupied. Remove memory module blanks only if you intend to install memory modules in those sockets.
1. Follow the safety guidelines listed in safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the cooling shroud.
Steps
1. Locate the appropriate memory module socket(s).
2. To release the memory module from the socket, simultaneously press the ejectors on both ends of the memory module socket.
CAUTION: Handle each memory module only by the card edges, ensuring not to touch the middle of the memory
module or metallic contacts.
3. Remove the memory module from the socket.
Figure 15. Removing the memory module
a. memory module
b. memory module socket
c. memory module ejector (2)
Next steps
1. If you are removing the memory module permanently, install a memory module blank. If you are installing a new memory module, see
the Installing the Memory Module section.
2. Follow the procedure listed in the After working inside your system section.
64 Installing and removing server module components