Table of Contents
Advertisement
2. Remove the server module from the enclosure.
3. Install the I/O connector cover.
4. Remove the system cover.
Related References
Safety instructions
on page 51
Related tasks
Removing the system cover
After working inside your system
Prerequisites
Follow the safety guidelines listed in safety instructions section.
Steps
1. Install the system cover.
2. Install the server module in the enclosure.
3. Turn on the server module.
Related References
Safety instructions
on page 51
Related tasks
Installing the system cover
Recommended tools
You may need the following items to perform the procedures in this section:
•
Phillips #1 and #2 screwdrivers
•
T8 and T10 Torx drivers
•
Wrist grounding strap
•
Hex nut driver-5 mm
Installing and removing a server module
NOTE:
Server modules that are specifically configured for the PowerEdge VRTX enclosure, can be identified by a label
marked PCIe on the server module.
NOTE:
Ensure that you have downloaded the latest BIOS on the server module(s) from Dell.com/support/home.
Removing a server module
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that came with the product.
1. Follow the safety guidelines listed in safety instructions section.
52
Installing and removing server module components
on page 56
on page 57
Advertisement
Table of Contents
Troubleshooting
