Dell PowerEdge M630p Owner's Manual page 120

Figure 65. Removing the NVRAM backup battery
a. positive side of battery
b. negative side of battery connector
Figure 66. Installing the NVRAM backup battery
a. positive side of battery
b. negative side of battery connector
Next steps
1. Install the following:
a. System board
b. IDSDM or rSPI card
c. NDC
d. PCIe mezzanine cards
e. Hard drive or SSD cage
f. Hard drive or SSD backplane
g. Cooling shroud
h. Hard drives or SSDs
2. Follow the procedure listed in the After working inside your system section.
3. Enter the System Setup to confirm that the battery is operating properly.
4. Enter the correct time and date in the System Setup's Time and Date fields.
5. Exit the System Setup.
6. To test the newly installed battery, remove the server module for at least an hour.
7. Reinstall the server module after an hour.
8. Enter the System Setup and if the time and date are still incorrect, see the Getting help section.
Related References
Getting help on page 133
Safety instructions on page 51
Related tasks
Before working inside your system
120 Installing and removing server module components
on page 51