Controller Access; Controller Use Replacement; Element Check - Smoke hollow WS30C Manual

Pellet smoker
Table of Contents

Advertisement

Available languages

Available languages

CONTROLLER ACCESS

1. Turn off the smoker and allow to cool to touch.
2. Unplug from outlet.
3. Remove four screws from controller faceplate.
4. Remove controller from housing.
5. Disconnect and reconnect all connections.
• Main power connection
• Auger motor connection
• Intake fan connection
• Temp probe connection
6. Place controller in housing.
7. Install four screws in controller faceplate.
CONTROLLER FUSE REPLACEMENT
1. Turn off smoker and allow to cool to touch.
2. Unplug from outlet.
3. Remove four screws from controller faceplate.
4. Remove controller from housing.
5. Locate black fuse housing and remove fuse.
6. Install new 5 amp, 5mmx11mm fuse in fuse housing.
7. Place controller in controller housing.
8. Install four screws in controller faceplate.

ELEMENT CHECK

1. Turn off smoker and allow to cool to touch.
2. Remove cooking racks, water bowl, grease deflector and heat diffuser.
3. Clean out any ash, pellets or debris in crucible.
4. Turn unit on and set the cook cycle. Check that heating light is on.
• If heating light does not come on, contact Smoke Hollow
5. Element should begin to turn red. If element does not begin to turn red, check the connection to
controller. Reference Controller Access instructions.
6. Repeat check after securing connection. If element still does not work, contact Smoke Hollow
replacement.
40
for support.
®
for
®

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sh19252519

Table of Contents